top of page
Forum Posts
elizabeth
Jul 19, 2023
In Help From The Community
Hello all, I am a fashion designer (leather, apparel and home) in California. One of my specialties are leather totes with our logo debossed in gold foil. Can anyone please give advice as to how to fix a poor foil deboss on uneven leather (croc, etc.) and to touch up old logo debosses? When I went over a second time with a new press and foil, it became sloppy as it wasn't exactly in the same spot. Does anyone know of a good way to do this by hand? I was thinking of heating up some hand tools and touching up the spots. But I know I am not the only one who has experienced this. Advice welcome!
2
12
97
elizabeth
Apr 27, 2022
In Help From The Community
Hi all, I am getting started on a beginner project for a friend - making a simple veg tan leather folder for his restaurant staff to deliver checks to clients. Objective is to have an eventual saddle tan color that shows patina with time and I will stamp his logo on the front. I bought natural veg tan have a few questions and would appreciate any guidance. Here are the steps I have taken thus far: A) I cut the leather 8.5 wide by 9 inches tall; 3.29mm thick B) I placed them outside to tan (only one day so far but will want a deeper color). C) I made a simple, flat wooden "mold" by cutting a piece of 6mm wood (see photos) Questions for community: 1) Should I coat them with linseed oil prior to tanning to prevent drying? I don't want them to be super stiff and will want to prevent drying out over time. 2) How do I work to finish the raw, flat inside to make it a bit smoother? Should I skive it down/split it to be thinner? 3) How do I make a cut in the center to allow for an easier fold? I tried using my edger but it is not getting the deeper, wider groove desired. 4) I tested soaking a piece of leather for 15 minutes in water, then molding it (without the groove). It is a bit thick and doesn't close flush, so the groove I think is needed. But once dried, it is super stiff leather compared to the other pieces not soaked. Any mold advice? Thank you all for any contributions on my "hands on" second project after simple belts! Best, Elizabeth
2
10
160
elizabeth
More actions
bottom of page